x

Overview

THERMOcure: Drying with warm air and infrared radiation

THERMOcure

Drying with warm air and infrared radiation

Many drying processes require the release of the solvent. The best-known solvent is water. To accelerate proceedings, energy in form of heat is supplied. This is called an evaporation of water.

Depending on the machine speed, the solvent content and the film thickness, a particular drying line and hence amount of energy is needed. The required energy can be pulled from different combinations of IR radiators, carbon radiators and warm air.

The THERMOcure is completely erected in a cassette. Depending on the spatial conditions, there are different standard widths available. Individual adjustments are possible. For a fast lamp change, the cable clamps of the IR radiators are accessible from below.

Benefits

IRM radiators
They effect a fast energy supply and hence a fast heating of the ink film. 0.9 - 2.9 μm (peak width at halfheight) is the typical wavelength area of medium-wave IR radiators.
IRC radiators
In contrast to IRM radiators, carbon radiators effect a stronger warming near the surface of the wet film. 1.1 - 3.7 μm (peak width at half-height) is the typical wavelength area of carbon radiators.
Warm air
Warm air is produced in a heating register in order to maintain the temperature level and to peel off the solvent from the surface. Therefore warm air is applied on the film surface at high speed via a blow opening with optimised nozzle function.
Construction
The WIR dryer is completely erected in a cassette. Depending on the spatial conditions, there are different standard widths available. Individual adjustments are possible. For a fast lamp change, the cable clamps of the IR radiators are accessible from below.
Configuration
The construction widths decide over the configuration possibilities. A selection between IR or carbon radiator is possible per cassette. We are pleased to share our knowledge in this area. Radiators are completely dispensable on request. The following table describes the maximum occupancy.
Technical data
Both the temperature and the radiator power can be continously regulated. Hence the optimum adaptation to the process is guaranteed.

Information

Construction

The W/IR dryer is completely erected in a cassette. Depending on the spatial conditions, there are different standard widths available. Individual adjustments are possible. For a fast lamp change, the cable clamps of the IR radiators are accessible from below.

Width (mm) Nozzles Radiators
320 4 2
520 6 3
720 8 4

 

THERMOcure: Drying with warm air and infrared radiation

Downloads